loose front rail pins

[PIANO2NR at aol.com]

In a message dated 11/1/2006 6:21:35 PM Eastern Standard Time, 
josephspiano at comcast.net writes:
I urge those that use CA on front rail pins to not use the thinnest CA 
available. My reasons are as follows:

1) If the pins are so loose that they rotate too readily, then the thin glue 
will surely flow clear through to the other side, maybe even getting on the 
punchings and felt or up into the key bushings. (Assuming you're looking for an 
expedient method, rather than total disassembly) 
When I suggested thinnest CA, I meant a drop or two applies around the base 
of the pin from the top with the punchings removed.

Randy Mangus
Mangus Piano Service
140 Atkinson Ave.
Wheeling, WV 26003
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.ptg.org/pipermail/pianotech/attachments/20061101/62e88568/attachment.html