loose front rail pins

[Avery]

At 05:29 PM 11/1/2006, you wrote:
>In a message dated 11/1/2006 6:21:35 PM Eastern Standard Time, 
>josephspiano at comcast.net writes:
>I urge those that use CA on front rail pins to not use the thinnest 
>CA available. My reasons are as follows:
>
>1) If the pins are so loose that they rotate too readily, then the 
>thin glue will surely flow clear through to the other side, maybe 
>even getting on the punchings and felt or up into the key bushings. 
>(Assuming you're looking for an expedient method, rather than total 
>disassembly)
>
>When I suggested thinnest CA, I meant a drop or two applies around 
>the base of the pin from the top with the punchings removed.

Isn't that how most techs would do it? I hope so! :-)

>
>Randy Mangus
>Mangus Piano Service
>140 Atkinson Ave.
>Wheeling, WV 26003
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.ptg.org/pipermail/pianotech/attachments/20061101/68c440e5/attachment.html