Agraffe Counterbore Tool

[BobDavis88 at aol.com]

In a message dated 5/23/2007 9:04:22 PM Pacific Daylight Time, 
mfarrel2 at tampabay.rr.com writes:

I wish I could chuck it into my 1/2" drill press. This thing just reeks of 
some special purpose to the taper, etc. - what the heck is it supposed to mount 
in?

Most likely a Morse taper. It's for mounting directly into a matching 
receiver on many machine tools, like lathes and drill presses. It works well, and is 
quick to get in and out. You might check to see if your drill press chuck is 
mounted into the spindle this way. Mine is (Jet floor model drill press). There 
are eight sizes of Morse taper, and a Jacobs taper, and some more, but the 
most common one in tools of this size is the #2MT, and who knows, it might just 
fit right into your drill press.
 
Bob Davis



************************************** See what's free at http://www.aol.com.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.ptg.org/pipermail/pianotech/attachments/20070524/0877faf8/attachment.html