Tuning pin drilling? followup

[Erwinspiano at aol.com]

Gotch
  I also will refine my set up & give another fair hearing. Thanks  of 
sharing....Dude
  Dale

When I'm drilling on a stationary press I never drill twice & my  
> pin fit is very consistent.For me it's so much quicker easier. I also  
>  have a very accurate way of determining the plate hole center  which I 
> like & so I probably won't switch any time  soon.
>   Dale

Whatever works for you. I find that two  quick passes takes 
maybe 10-15 minutes longer total then one careful and  
controlled pass and produces a better job in my shop without 
blowing  insufficiently dehumidified air at the bit and block. 
I ain't selling  the technique, just sharing something I 
learned along the way that might  benefit someone else as it 
has me.
Ron N


 



************************************** See what's new at http://www.aol.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.ptg.org/pipermail/pianotech/attachments/20071001/16abe26d/attachment.html