Yamaha pedal pivot

[tom]

Subject: Re: Yamaha pedal pivot

Thanks, Tom. I've seen Eric Shandall demonstrate this trick on the 
shift-pin guide plates in S&S cheek blocks to great effect. In this case 
however the wear is pretty extreme (~2mm), so I'll be trying Ron's 
suggestion of J B Weld (I was secretly hoping that somebody would 
suggest it, Ron). That sounds a lot cheaper than a new set of pedals ;-)

- Mark Dierauf

	
Mark,
	I agree. JB weld would be my choice with that much wear. It's
available in most hardware stores also.
	Tom d.

No virus found in this outgoing message.
Checked by AVG. 
Version: 7.5.524 / Virus Database: 269.23.6/1403 - Release Date: 4/29/2008
7:26 AM